Search

Background Patella resurfacing in total knee arthroplasty is a contentious issue. The literature suggests that resurfacing of the patella is based on surgeon preference, and little is known about the role and timing of resurfacing and how this affects outcomes. Methods We analyzed 134,799 total knee arthroplasties using data from the Australian Orthopaedic Association National Joint Replacement Registry. Hazards ratios (HRs) were used to compare rates of early revision between patella resurfacing at the primary procedure (the resurfacing group, R) and primary arthroplasty without resurfacing (no-resurfacing group, NR). We also analyzed the outcomes of NR that were revised for isolated patella addition. Results At 5 years, the R group showed a lower revision rate than the NR group: cumulative per cent revision (CPR) 3.1% and 4.0%, respectively (HR = 0.75, p < 0.001). Revisions for patellofemoral pain were more common in the NR group (17%) than in the R group (1%), and “patella only” revisions were more common in the NR group (29%) than in the R group (6%). Non-resurfaced knees revised for isolated patella addition had a higher revision rate than patella resurfacing at the primary procedure, with a 4-year CPR of 15% and 2.8%, respectively (HR = 4.1, p < 0.001). Interpretation Rates of early revision of primary total knees were higher when the patella was not resurfaced, and suggest that surgeons may be inclined to resurface later if there is patellofemoral pain. However, 15% of non-resurfaced knees revised for patella addition are re-revised by 4 years. Our results suggest an early beneficial outcome for patella resurfacing at primary arthroplasty based on revision rates up to 5 years. [ABSTRACT FROM AUTHOR]

Background Metal particles are generated during bone preparation in knee arthroplasty. These particles may produce third-body wear, or may have a role in osteolysis. Knowledge of their characteristics may help in the development of methods to reduce the amount of metal debris during bone cutting procedures. Material and methodsWe performed bony resection of the distal femur and proximal tibia on 15 pig knees, simulating a total knee arthroplasty (TKA). Metal debris was collected from the saw blades, cutting blocks and bone surfaces and cleaned for microanalysis. Results The average loss of metal from the saw blades was 1.13 mg. The average volume of a wear particle was 3.4 × 10 -16 m 3 . From this, it was estimated that approximately 500,000 particles are released from the saw blade alone. Material analysis of the particles indicated that the majority originated from the metallic cutting guides, suggesting that many millions of wear particles would be generated during the surgical procedure. Two particle shapes predominated: platelet shape and ploughed shape. Interpretation Wear particles are produced during resection for a TKA. These may enter the artificial articulation and cause accelerated wear and macrophage activation. Redesign of cutting blocks and saw blades may reduce the amount of debris produced during surgery. [ABSTRACT FROM AUTHOR]