Search

New coordination polymers with 2D network structures with fluorine directly coordinated to the metal ion were prepared both via mechanochemical synthesis and fluorolytic sol–gel synthesis. Depending on the synthesis route, the samples show different particle sizes, according to SEM imaging. The crystal structures of barium acetate fluoride, strontium acetate fluoride, and lead acetate fluoride (BaF(CH3COO), SrF(CH3COO) and PbF(CH3COO)) were solved from X-ray powder diffraction data. The structure solution is backed by the results from 19 F MAS NMR, FT IR data, and thermal analysis. The calculated chemical shifts of the 19 F MAS NMR spectra coincide well with the measured ones. It turns out that the grinding conditions have a remarkable influence on the mechanochemical synthesis and its products. Our systematic study also indicates a strong influence of the atomic radii of Ca, Sr, Ba, and Pb on the success of the syntheses. [ABSTRACT FROM AUTHOR]

The short-wavelength sub-nanosecond luminescence in BaF 2 material, discovered in the early 80s, gave a new direction to research into fast scintillators and phosphors. In contrast to 'typical' luminescence occurring within the forbidden band gap, the new type of emission was due to transitions between the upper core and valence bands. Thus it was named core-valence luminescence (CVL); the terms cross-luminescence and Auger-free luminescence have also been used. Given its unusual nature, this new luminescence process has attracted considerable interest in the field of condensed matter physics. During the sequent decades (till the end of the previous century) CVL has been experimentally observed in several dozen compounds and the conditions for detecting CVL have been established. Interest in this kind of luminescence increased in recent years due to the emergence of new methods of crystal synthesis, the development of high-speed solid-state photodetectors, and the construction of unique modern set-ups using synchrotron radiation. This paper analyzes the numerous studies of CVL, obtained mainly over the past decade. Experimental and theoretical data on this topic are considered in detail. Special attention is given to new results on scintillation characteristics of BaF 2 in the form of single crystals, ceramics, nanoparticles, and composites. The features of CVL in binary and ternary compounds are discussed. Some Cs- and Ba-based ternary halides show relatively high light yields and represent promising fast scintillators. The prospects of using materials with CVL as fast scintillators for time-of-flight positron emission tomography and other applications are deliberated. • Overview of recent theoretical and experimental findings on Core Valence luminescence. • Most attractive CVL crystals for ultrafast scintillator applications analyzed. • Prospects for future studies and underexplored CVL materials listed. [ABSTRACT FROM AUTHOR]

The NL-eEDM collaboration is building an experimental setup to search for the permanent electric dipole moment of the electron in a slow beam of cold barium fluoride molecules [NL-eEDM Collaboration, Eur. Phys. J. D 72, 197 (2018)]. Knowledge of the molecular properties of BaF is thus needed to plan the measurements and, in particular, to determine the optimal laser-cooling scheme. Accurate and reliable theoretical predictions of these properties require the incorporation of both high-order correlation and relativistic effects in the calculations. In this work, theoretical investigations of the ground and lowest excited states of BaF and its lighter homologs, CaF and SrF, are carried out in the framework of the relativistic Fock-space coupled cluster and multireference configuration interaction methods. Using the calculated molecular properties, we determine the Franck-Condon factors (FCFs) for the A 2 Π 1 / 2 → X 2 Σ 1 / 2 + transition, which was successfully used for cooling CaF and SrF and is now considered for BaF. For all three species, the FCFs are found to be highly diagonal. Calculations are also performed for the B 2 Σ 1 / 2 + → X 2 Σ 1 / 2 + transition recently exploited for laser-cooling of CaF; it is shown that this transition is not suitable for laser-cooling of BaF, due to the nondiagonal nature of the FCFs in this system. Special attention is given to the properties of the A′2Δ state, which in the case of BaF causes a leak channel, in contrast to CaF and SrF species where this state is energetically above the excited states used in laser-cooling. We also present the dipole moments of the ground and excited states of the three molecules and the transition dipole moments (TDMs) between the different states. Finally, using the calculated FCFs and TDMs, we determine that the A 2 Π 1 / 2 → X 2 Σ 1 / 2 + transition is suitable for transverse cooling in BaF. [ABSTRACT FROM AUTHOR]

Single crystals of Ca1– хBaхF2 (x = 0.001–0.05 and 0.85–0.99) solid solutions have been grown by the Bridgman method, and their thermal conductivity has been measured in the range 50–300 K by an absolute steady-state axial heat flow technique. The thermal conductivity of all samples has been shown to decrease with increasing temperature. At 300 K, the lowest thermal conductivity of the samples with x ≤ 0.05 exceeds 6 W/(m K), and that of the samples with x ≥ 0.85 is a factor of 2 lower. [ABSTRACT FROM AUTHOR]

Featured Application: laser surface-processing. Monocrystalline barium fluoride (BaF2) slab targets were irradiated by focused 46.9-nm laser radiation at various fluence levels above the ablation threshold. Well-developed ablation patterns with sharp edges were studied by AFM (atomic force microscopy). Their inner surfaces were uniformly covered by periodic structures. The spatial period of the ripples depends on the laser fluence. When the sample is rotated by 45°, the orientation of the grating-like structure changes accordingly. Thus, the grating vector of the periodic structure seems to be coupled to the crystallographic planes of the single crystal. This means that the XUV-laser induced ripples reported here differ from LIPSS (laser-induced periodic surface structures) associated with interference phenomena occurring on illuminated surfaces. Therefore, other mechanisms are discussed to explain the formation of the periodic nanostructures reported in this article. [ABSTRACT FROM AUTHOR]

Barium fluoride (BaF2) crystals are attracting much attention as efficient inorganic scintillator promising for high‐energy physics, industrial inspection, and other fields because of the fast component of the decay time (0.6 ns) and high radiation resistance. However, two major drawbacks limit its practical application: (i) a slow decay time of ~600 ns is derived from self‐trapping excitons; (ii) the absolute light yield from the fast luminescence component is not competitive. The introducing of rare earth ions and preparation of BaF2 polycrystalline ceramics is considered to be effective measures to solve these bottlenecks. Pr3+ is extremely suitable as the activated ion of scintillation materials, which possess emission peaks located in visible band and the faster 5d–4f transition. In this work, highly sinterable Pr3+:BaF2 precursor powder was synthesized via the coprecipitation method by adjusting the reactant concentration and temperature. The morphology and microstructure of as‐synthesized powders were characterized using scanning electron microscopy (SEM) and transmittance electron microscopy analysis. The 5 at.% Pr3+:BaF2 transparent ceramic with a transmittance of 50.7% at the wavelength of 500 nm was fabricated by hot pressing the as‐prepared powders at 900°C for 4 h under the axial pressure of 50 MPa. The SEM images of ceramic cross‐section show that the residual pore is the main light scattering source. The absorption and emission spectrum of ceramic samples were discussed. [ABSTRACT FROM AUTHOR]

We introduce FeCo‐BaF and FeCo‐SiN nanogranular films exhibiting giant Faraday effect. These films have a nanocomposite structure, in which nanometer‐sized FeCo ferromagnetic granules are dispersed in BaF2 or Si3N4 matrix. FeCo‐BaF film has a good figure of merit of Faraday effect from the crystalized BaF2 matrix. FeCo‐SiN film has a large refraction index from the nature of Si3N4 matrix. These properties contribute to the practical application of nanogranular films to optical devices. [ABSTRACT FROM AUTHOR]

Our recent study was focused on the emission from Laser Induced Plasma (LIP) at the delay times of tenths of microseconds after the laser pulse. At these long delays, the spectrum is dominated by the broadband molecular emission and plasma induced luminescence (PIL) produced by a luminescent matrix; only solitary atomic emission lines can be seen. Barium fluoride BaF 2 activated by thulium (Tm) is a famous scintillator that presents the promising object for LIP in terms of both the potential for BaF molecular emission and Tm3+ PIL. The detection of molecular and PIL bands presents a new opportunity for analysis of halogens and rare-earth elements, which are the difficult objects for LIBS. In this paper, we show that the UV, Green, Extreme Red, and Infrared molecular bands from BaF and blue luminescence from Tm3+ are present in the LIP emission spectra while the detection of atomic emission from F I and Tm I was impossible with the same experimental setup. Thus, the detection of molecular emission and PIL can be more sensitive than the traditional detection of emission from atoms and ions. Unlabelled Image • We studied LIBS of BaF 2 activated by Tm3+. • Emission and temporal behavior of BaF molecules were determined. • Plasma Induced Luminescence of Tm3+ was found. [ABSTRACT FROM AUTHOR]