Search

Ionospheric delay is one of the most problematic errors in single-frequency (SF) global navigation satellite system (GNSS) data processing. Global/regional ionospheric maps (GIM/RIM) are thus vitally important for positioning users. Given the coexistence of multi-GNSS, the integration of quad-constellation observations is essential for improving the distribution of ionospheric penetration points (IPPs) and increasing redundant observations compared with the existing GIM products from the IGS analysis center. In this paper, quad-constellation (GPS/GLONASS/Galileo/BDS) observations are applied to set up the RIM over Australia with uncombined precise point positioning (UC-PPP) and a low-order spherical harmonic function. The generated RIMs are then introduced to ionosphere-corrected (IC) and ionosphere-weighted (IW) single-frequency PPP (IC-SFPPP and IW-SFPPP) to verify their performance in terms of positioning accuracy and convergence time. Taking the CODE GIM as a reference, the results show that the mean root mean square (RMS) of VTEC differences is 0.867 TECUs, and the quad-constellation RIM (referred as 'RIM4′) can improve the RMS of RIMs compared to single-constellation mode at the edge of regional experiment area. The application of the RIM4 in the BDS IC-SFPPP results in a 18.38% improvement (from 100.47 cm to 82.00 cm) of 3D positioning RMS compared to the CODE-GIMs, whereas 35.36% enhancement (from 115.92 cm to 74.62 cm) of 3D positioning RMS is achievable during an active ionospheric period. Moreover, if the criterion of the convergence time is defined as when positioning errors in the horizontal and vertical directions are less than 0.3 m and 0.6 m for 20 consecutive epochs, the IW-SFPPP can significantly speed up the convergence time compared to the uncombined SFPPP; that is, the convergence time is reduced by 52.7% (from 37 min to 17.5 min), 37.2% (from 72.5 min to 45.5 min), and 37.1% (from 62.0 min to 39.0 min) in the north, east and up direction, respectively, at the 68% confidence level. [ABSTRACT FROM AUTHOR]

This paper presents a soil moisture retrieval scheme from Cyclone Global Navigation Satellite System (CYGNSS) delay-Doppler maps (DDMs) over land. The proposed inversion method consists of a hybrid global and local optimization method and a physics-based bistatic scattering forward model. The forward model was developed for bare-to-densely vegetated terrains, and it predicts the circularly polarized bistatic radar cross section DDM of the land surface. This method was tested on both simulated DDMs and CYGNSS DDMs over the Soil Moisture Active Passive (SMAP) Yanco core validation site in Australia. About 250 CYGNSS DDMs from 2019 and 2020 over the Yanco site were used for validation. The simulated DDMs were for grassland and forest vegetation types. The vegetation type of the Yanco validation site was grassland. The vegetation water content (VWC) was 0.19   kg m − 2 and 4.89   kg m − 2 for the grassland and forest terrains, respectively. For the case when the surface roughness is known to the algorithm, the unbiased root mean square error (ubRMSE) of soil moisture estimates was less than 0.03   m 3 m − 3 while it was approximately 0.06   m 3 m − 3 and 0.09   m 3 m − 3 for the validation results from 2019 and 2020, respectively. The retrieval algorithm generally had enhanced performance for smaller values of soil moisture. For the case when both the soil moisture and surface roughness are unknown to the algorithm and only a single DDM is used for retrieval, the validation results showed an expected reduced performance, with an an ubRMSE of less than 0.12   m 3 m − 3 . [ABSTRACT FROM AUTHOR]

This paper describes a computation method for obtaining dielectric constant using Global Navigation Satellite System reflectometry (GNSS-R) products. Dielectric constant is a crucial component in the soil moisture retrieval process using reflected GNSS signals. The reflectivity for circular polarized signals is combined with the dielectric constant equation that is used for radiometer observations. Data from the Cyclone Global Navigation Satellite System (CYGNSS) mission, an eight-nanosatellite constellation for GNSS-R, are used for computing dielectric constant. Data from the Soil Moisture Active Passive (SMAP) mission are used to measure the soil moisture through its radiometer, and they are considered as a reference to confirm the accuracy of the new dielectric constant calculation method. The analyzed locations have been chosen that correspond to sites used for the calibration and validation of the SMAP soil moisture product using in-situ measurement data. The retrieved results, especially in the case of a specular point around Yanco, Australia, show that the estimated results track closely to the soil moisture results, and the Root Mean Square Error (RMSE) in the estimated dielectric constant is approximately 5.73. Similar results can be obtained when the specular point is located near the Texas Soil Moisture Network (TxSON), USA. These results indicate that the analysis procedure is well-defined, and it lays the foundation for obtaining quantitative soil moisture content using the GNSS reflectometry results. Future work will include applying the computation product to determine the characteristics that will allow for the separation of coherent and incoherent signals in delay Doppler maps, as well as to develop local soil moisture models. [ABSTRACT FROM AUTHOR]