Search

This paper mainly dealt with the technical and economic feasibility of an off-grid hybrid power generation system for a remote rural Turtuk village of Ladakh, located in the northern part of India. The study showed that the proposed configured renewable integrated hybrid system, using Hybrid Optimization of Multiple Energy Resources (HOMER) software, efficiently met the energy demand, exhibiting optimum performance with low investment. The proposed PV(115 kW)/Wind(1 kW)/Battery(164 strings of 6 V each)/DG(50 kW) hybrid system was a highly commendable, feasible solution preferred from a total of 133,156 available solutions resulting from HOMER simulations. The net present cost and energy cost of the proposed configuration were $278,176 and $0.29/kWh, respectively. The proposed hybrid configuration fulfilled local load, with 95.97% reduced dominant harmful carbon dioxide emission, as compared to the sole us of a diesel generator power supply system. The technical performance of the hybrid system was ensured, with advantages including the highest renewable penetration and least unmet load. Furthermore, the analysis exclusively evaluated the impact of the system's economic parameters (namely, its expected inflation rate, nominal discount rate, and project lifetime) on the net present cost and cost of energy of the system using a noble single fix duo vary approach. [ABSTRACT FROM AUTHOR]

Solar photovoltaic (SPV) installations are growing in the distribution network due to the continuously decreasing prices of solar photovoltaic panels. Installing the SPV Plant on the distribution feeder supplying to the agricultural pumps is a challenging task due to the varying agricultural load pattern of the Agricultural Feeder (AG Feeder). Supply of power and demand creates potential challenges in the low voltage (LV) distribution system. This paper presents a case study of a 2 MW SPV connected to an agricultural feeder in India. Performance analysis has been carried out using field measurement data. The key parameters such as PV Penetration and Capacity Utilization Factor (CUF) are calculated for analysis. Parameters such as Grid Dependency of the load and PV Contribution have been introduced in this paper, which relates to the SPV system behavior more aptly. It is recommended that the Time of Day (ToD) metering with the lowest cost during the solar generation hours will make agricultural consumers shift their demand matching with solar generation hours. Extensive analysis of agricultural feeder connected SPV power plant indicates that the power supply has improved for the feeder during winter and summer months. [ABSTRACT FROM AUTHOR]

By considering the weight penalty of batteries on payload and total vehicle weight, this paper shows that almost all forms of land-based transport may be served by battery electric vehicles (BEV) with acceptable cost and driving range. Only long-distance road freight is unsuitable for battery electrification. The paper models the future Indian electricity grid supplied entirely by low-carbon forms of generation to quantify the additional solar PV power required to supply energy for transport. Hydrogen produced by water electrolysis for use as a fuel for road freight provides an inter-seasonal energy store that accommodates variations in renewable energy supply. The advantages and disadvantages are considered of midday electric vehicle charging vs. overnight charging considering the temporal variations in supply of renewable energy and demand for transport services. There appears to be little to choose between these two options in terms of total system costs. The result is an energy scenario for decarbonized surface transport in India, based on renewable energy, that is possible, realistically achievable, and affordable in a time frame of year 2050. [ABSTRACT FROM AUTHOR]

With the negative climate impact of fossil fuel power generation and the requirement of global policy to shift towards a green mix of energy production, the investment in renewable energy is an opportunity in developing countries. However, poor economy associated with limited income, funds availability, and regulations governing project funding and development are key factors that challenge investors in the energy sector. Given the various power generation resources, including renewables, it is necessary to evaluate the possible power generation investment options from an economic perspective. To realize this objective, solar PV, wind and diesel power generations are economically compared, considering the incremental rate of return and incremental benefit to cost ratio techniques. The alternative investment options of distributed generation technologies are evaluated for Maharashtra, India under different depreciation methods, and the effect of the latter on selecting the best investment candidate is investigated. The paper also conducts sensitivity analysis to examine the impact of capital cost, operation and maintenance cost, and fuel cost variations on the selection decision considering a comparison of the different general projects' cash flow structures discussed in the literature. The economic aspects of selecting a project among possible alternatives for an investment in the power sector are analyzed, and the presented review provides comprehensive comparisons with respect to the literature approaches. The results reveal that, in the benchmark case study, the PV project is rejected and disregarded from further comparisons with other candidate projects since its equity internal rate of return (10.25%) is less than the minimum accepted rate of return, leaving the selection between wind and diesel energy projects. The study reveals that the incremental rates of return under such a comparison are 37.88%, 45.94% and 37.50% when MACRS, declining balance and straight line depreciations techniques are applied, respectively. Thus, the wind energy project is the favored option in this case. For the economic assessment of other case studies, the application of both sensitivity analysis on the capital cost and operation and maintenance cost and literature approaches to structure the projects reveal that wind energy for Maharashtra, India is a more attractive and feasible option compared to other distribution generation projects, while diesel is only considered to be a good option when its fuel cost is reduced by 5%. Finally, the paper highlights policy implications that can influence the decision to move towards investment in distributed generation technologies as a future research direction. [ABSTRACT FROM AUTHOR]

Higher penetration of variable renewable energy sources into the grid brings down the plant load factor of thermal power plants. However, during sudden changes in load, the thermal power plants support the grid, though at higher ramping rates and with inefficient operation. Hence, further renewable additions must be backed by battery energy storage systems to limit the ramping rate of a thermal power plant and to avoid deploying diesel generators. In this paper, battery-integrated renewable energy systems that include floating solar, bifacial rooftop, and wind energy systems are evaluated for a designated smart city in India to reduce ramping support by a thermal power plant. Two variants of adaptive-local-attractor-based quantum-behaved particle swarm optimization (ALA-QPSO) are applied for optimal sizing of battery-integrated and hybrid renewable energy sources to minimize the levelized cost of energy (LCoE), battery life cycle loss (LCL), and loss of power supply probability (LPSP). The obtained results are then compared with four variants of differential evolution. The results show that out of 427 MW of the energy potential, an optimal set of hybrid renewable energy sources containing 274 MW of rooftop PV, 99 MW of floating PV, and 60 MW of wind energy systems supported by 131 MWh of batteries results in an LPSP of 0.005%, an LCoE of 0.077 USD/kW, and an LCL of 0.0087. A sensitivity analysis of the results obtained through ALA-QPSO is performed to assess the impact of damage to batteries and unplanned load appreciation, and it is found that the optimal set results in more energy sustainability. [ABSTRACT FROM AUTHOR]

Agriculture residue is a promising resource of energy. It can be seen as a source of power production. In India, there is a huge amount of biomass available, but it cannot be used in proper ways, and with the help of GIS it can be customised. In the present paper, it is estimated that biomass reserves are available for power generation. The biomass produced by the surplus agricultural crops is reflected as a source of fuel for electricity generation. The data taken by satellite are useful for assessment of the areas with the help of satellite images taken in high resolution, which increases the preciseness of estimation. An agriculture cropland map with agricultural statistics has been analyzed in GIS to discover the agricultural straw potential for bioenergy generation. Due to unawareness about the benefits and uses of GIS, the modern farming sector bears a loss of huge bioenergy potential every year. To overcome the above mentioned challenges, the agricultural system needs a major shift from conventional farming to smart farming practices with the help of GIS. Agricultural waste is the best source for bioenergy production, and it can be used as biomass for meeting renewable energy goals in the country. [ABSTRACT FROM AUTHOR]

Reliable access to electricity is still a challenge in many developing countries. Indeed, rural areas in sub-Saharan Africa and developing countries such as India still encounter frequent power outages. Local energy markets (LEMs) have emerged as a low-cost solution enabling prosumers with power supply systems such as solar PV to sell their surplus of energy to other members of the local community. This paper proposes a one-to-one automated negotiation framework for peer-to-peer (P2P) local trading of electricity. Our framework uses an autonomous agent model to capture the preferences of both an electricity seller (consumer) and buyer (small local generator or prosumer), in terms of price and electricity quantities to be traded in different periods throughout a day. We develop a bilateral negotiation framework based on the well-known Rubinstein alternating offers protocol, in which the quantity of electricity and the price for different periods are aggregated into daily packages and negotiated between the buyer and seller agent. The framework is then implemented experimentally, with buyers and sellers adopting different negotiation strategies based on negotiation concession algorithms, such as linear heuristic or Boulware. Results show that this framework and agents modelling allow prosumers to increase their revenue while providing electricity access to the community at low cost. [ABSTRACT FROM AUTHOR]