Search

The increasing presence of non-programmable renewable energy plants increases the intermittency of the electricity supply and thus threatens the adequacy of a power system. Hydropower can solve this problem due to its flexibility. This paper applies statistical approaches to assess water availability in the context of hydropower generation and adequacy analysis on a seasonal basis for one site in Sicily and the other in Sardinia, where major hydroelectric plants are present. First, an empirical relationship between soil moisture content (SMC) and potential evapotranspiration (ET0) is evaluated through linear regression analysis. Then, precipitation trends over the last twenty years are analyzed to determine any effects of global warming on water availability. Finally, Monte Carlo algorithms are used for the stochastic generation of hourly precipitation, direct runoff profiles, and daily SMC profiles. Strong positive and negative correlations between ET0 and SMC (p < 0.05), and R2 ≥ 0.5 are found for both sites, except for summer, and R2 ≥ 0.5 is obtained. The cumulative pH-historical precipitation shows changes in seasonal trends, with evidence of a decrease at the annual level. The algorithms used to synthetically generate hourly precipitation and direct runoff profiles, as well as daily SMC profiles, effectively simulate the statistical variability of the historical profiles of these physical quantities. [ABSTRACT FROM AUTHOR]

The future buildings and society need to be resilient. This article aims to propose a novel concept of the energy resilience framework and implement a color-based rating system to quantify and rate the energy resilience performance of buildings in Nordic climates. The objective is to conduct a comparative analysis between old (1970s) and new (2020s) single-family buildings integrated with renewable energy sources and storage, assessing their energy resilience performance for heating during power outages, under extreme and typical climatic conditions. The study utilizes dynamic simulation of the buildings and renewable energy systems, conducting parametric studies to calculate proposed resilience indicators and rate their resilience performance, employing both passive and active methods. The total costs of the design variables are also calculated for economic evaluation. Given the complexities arising from climate change, the article uses a simplified method to synthesize regional climate to consider extreme climate change impacts on energy resilience performance. For the old building lacking PV, the robustness duration increased from 1 h to 3 h, and the degree of disruption (DoD) varied from 0.545 to 0.3 in extreme cold to warm climate scenarios, with the higher DoD number indicating worse performance. The impact of the season within the same climate scenario is also evident, as the habitability and robustness durations increased during spring compared to winter. The resilience improved with PV and battery. The new building showed that the robustness duration increased from 3 to 15 h, habitability durations increased, and the DoD varied from 0.496 to 0.22 from extreme cold to warm climates without renewables and storage. With the integration of PV and battery, the new building was able to achieve a lower DoD and better performance with lower PV and battery capacity, compared to the old building. Furthermore, utilizing the color grading method (red to green), optimal technical solutions and corresponding design variables were identified for each building type and climate scenario that could support decision-making. The total cost of the optimal solutions varied, as new buildings required lower costs to reach optimal performance. However, for optimal resilience performance during extreme cold climate scenarios, higher costs are required for each building type. The proposed resilience framework, indicators, color grading system, and costing could potentially support improvements in building regulations, ensuring the development of optimally resilient buildings, particularly in the face of extreme climatic conditions. [ABSTRACT FROM AUTHOR]

Energy is crucial to economic progress, but the contemporary worldwide population increase that demands greater energy generated from conventional exhaustible resources, an energy price upsurge, and environmental concerns, imperils sustainable economic growth. Nevertheless, switching to renewable energy produced from naturally replenished resources promotes energy security, likewise addressing issues such as global warming and climate change. This paper aims at exploring the influence and causal relation between renewable energy, both overall and by type, and sustainable economic growth of European Union (EU)-28 countries for the period of 2003-2014. We notice that the mean share of renewable energy in the gross final energy consumption is 15%, while the mean share of renewable energy in transport fuel consumption is 3%, which are below the thresholds of 20% and 10%, respectively, as set by the EU Directive 2009/28/EC. By estimating panel data fixed-effects regression models, the results provide support for a positive influence of renewable energy overall, as well as by type, namely biomass, hydropower, geothermal energy, wind power, and solar energy on gross domestic product per capita. However, biomass energy shows the highest influence on economic growth among the rest of renewable energy types. In fact, a 1% increase of the primary production of solid biofuels increases GDP per capita by 0.16%. Besides, cointegrating regressions set on panel fully modified and dynamic ordinary least squares regressions confirm the positive influence related to the primary production of renewable energies on economic growth. A 1% increase in primary production of renewable energies increases GDP per capita by 0.05%-0.06%. However, the results of Granger causality based on panel vector error correction model indicate both in short-run and long-run a unidirectional causal relationship running from sustainable economic growth to the primary production of renewable energies, being supported the conservation hypothesis. [ABSTRACT FROM AUTHOR]

In today's energy system, the diffusion of renewable-based technologies is accelerating rapidly. Development of mechanisms that support the large-scale deployment of renewables towards global warming and climate change mitigation continues to remain an issue of utter importance. The most important challenges the energy system of Kosovo faces today is the difficulty to meet all the demand for electricity, low operating efficiency and high release of greenhouse gas emissions, but specifically a large source of carbon dioxide (CO2). Consequently, this influences not only the stability of the system but the society as a whole. This paper addresses several possibilities for designing an adaptable energy system in Kosovo with the ability to balance electricity supply and demand which will meet the requirements for a more efficient, reliable and secure system. A new way of energy generating through integration of new renewable and non-renewable technologies is developed using the EnergyPLAN model. The system is based on available technologies: existing hydro, wind, photovoltaic (PV), combined heat and power (CHP) and new solar thermal, heat pumps and biomass. The baseline scenario 2015 was expanded by four additional scenarios, two for the year 2030 and two for the year 2050. The contribution of renewable sources in the primary energy supply (PES) in the performed scenarios was 14.8%, 34.1%, 38.4%, 69.7% and 68.3% respectively. Further, a very important component of this paper is the investigation of integrating carbon capture and sequestration (CCS) technology in the coal-based power plant as part of the analysis in the second scenario for 2050. The shift to zero-carbon energy system in Kosovo requires additional research and assessment in order to identify the untapped potential of renewable sources. However, from the results obtained it can be concluded that the goal of a secure, competitive and sustainable energy system in Kosovo state which will meet its long-term energy needs can be certainly achieved. [ABSTRACT FROM AUTHOR]

Sustainable energy development (SED) is a crucial component of the Sustainable Development Goals (SDG), aiming to maintain economic and social progress while protecting the environment and mitigating climate change's effects. SED serves as a transition paradigm for sustainable development, providing a blueprint for energy peace and prosperity for people and all uses. This article presents the history of SED and then uses a critical discourse approach to summarize existing review studies in SED. Ten interlinked themes of SED are identified, with two of them considered to be among the least studied in existing SED reviews and in the current global discussion around climate change. This study explores these two themes, which include energy financing and the need for 100% renewable energy (RE), a sub-theme of decarbonization strategy working towards the 1.5–2.0 °C scenario. The study suggests that the current G20 countries' contributions, if maintained continuously per annum, in addition to 80% more funding from private investment compared to the amount in the 1.5 °C scenario financial requirements for clean energy, are sufficient to limit global warming. In addition to the present drive for 100% RE, the article also discusses emerging issues, such as energy storage options with an indication of hydrogen as the most promising, other energy-related development agendas, and the need for regional security stability to prevent energy wars. Selected SED decarbonization strategies are presented across the power, transport, building, and industrial sectors. The study concludes with progress and directions for future research, mainly the need for re-defining nationally determined contribution (NDC) through an emissions budgeting and centralized global or regional emissions stock-taking strategy working towards the 1.5 °C scenario. [ABSTRACT FROM AUTHOR]

Solar energy harvesting using Photovoltaic (PV) systems is one of the most popular sources of renewable energy, however the main drawback of PV systems is their low conversion efficiency. An optimal system operation requires an efficient tracking of the Maximum Power Point (MPP), which represents the maximum energy that can be extracted from the PV panel. This paper presents a novel control approach for the Maximum Power Point Tracking (MPPT) based on the differential flatness property of the Boost converter, which is one of the most used converters in PV systems. The underlying idea of the proposed control approach is to use the classical flatness-based trajectory tracking control where a reference voltage will be defined in terms of the maximum power provided by the PV panel. The effectiveness of the proposed controller is assessed through numerical simulations and experimental tests. The results show that the controller based on differential flatness is capable of converging in less than 0.15 s and, compared with other MPPT techniques, such as Incremental Conductance and Perturb and Observe, it improves the response against sudden changes in load or weather conditions, reducing the ringing in the output of the system. Based on the results, it can be inferred that the new flatness-based controller represents an alternative to improve the MPPT in PV systems, especially when they are subject to sudden load or weather changes. [ABSTRACT FROM AUTHOR]

The development of collective and industrial energy systems, based on wood biomass, knows a significant increase since the end of the 90's in France, with more than 6000 power plants and heating plants developed currently. Because these systems are built for a minimal duration of 30 years, it is relevant to assess the availability of wood resources according to the potential impacts of global warming on five tree species mainly used in such a supply chain. The assessment of the potential spatial distribution of the suitable areas of these trees in 2050, by using the IPCC (Intergovernmental Panel on Climate Change) RCP6.0 scenario (Representative Concentration Pathway), shows an average decrease of 22% of the plots in comparison with the current situation. The results also point out that mountain areas would maintain a high probability of the development of four tree species. The assessment of the Net Primary Productivity (NPP) underlines a potential decrease for 93% of the plots in 2050, and an increase of this parameter in mountain areas. According to these assumptions, the proposed ecosystem based methodology can be considered as a prospective approach to support stakeholders' decisions for the development of the wood energy supply chain. [ABSTRACT FROM AUTHOR]