Search

This paper describes an experimental and numerical investigation to study the flexural capacity of back-to-back gapped built-up cold-formed steel (CFS) channel sections under four-point bending. The gap between the back-to-back channels was formed through intermediate link-channels which were screwed to the webs of the back-to-back channels. A total of 90 results comprising 18 laboratory tests and 72 finite element (FE) analysis results are reported on the flexural capacity of back-to-back gapped built-up CFS channel sections under four-point bending. Three different types of channels were considered to form the built-up channels: plain channels, channels with one web stiffener and channels with two web stiffeners. Two different beam spans as 1000 mm and 2000 mm were tested. Initial geometric imperfections were also measured prior to bending tests for all test specimens. A nonlinear FE model was then developed, the results of which showed good agreement against the laboratory test results. Using the validated FE model, an extensive parametric study was conducted to investigate the effects of web stiffeners and link-channel spacing on the flexural capacity of such gapped built-up beams. It is shown that design in accordance with the American Iron and Steel Institute, AISI (2016) and Australia/New-Zealand standards, AS/NZS (2018) can be conservative by as much as 27%. The flexural capacity of back-to-back gapped built-up sections with two web stiffeners was increased by 10% on average, when compared to the capacity of gapped built-up beams with plain channel sections. • Eighteen laboratory tests are reported on the flexural capacity of back-to-back gapped built-up CFS channel sections under four-point bending. • Three different types of channels: plain channels, channels with one web stiffener and channels with two web stiffeners were used to for the gapped built-up beams. • A nonlinear FE model was then developed, which included initial imperfections and modeling of link-channels and fasteners. • An extensive parametric study was conducted to investigate the effects of web stiffeners and link-channel spacing on the flexural capacity of such gapped built-up beams. • It is shown that design in accordance with the AISI & AS/NZS can be conservative by as much as 27%. [ABSTRACT FROM AUTHOR]