Search

• The web crippling behaviour of cold-formed steel channel section having elongated edge-stiffened web holes under interior-two-flange loading condition was studied numerically. • The results of a total of 1,227 new finite element analysis were reported. • Design formulae for the web crippling strength reduction factor were suggested. • A direct strength method (DSM) equation was also presented to evaluate web crippling strength. In the past decade, cold-formed steel (CFS) channel sections having circular edge-stiffened web holes have been developed in New Zealand. Such edge-stiffened holes increase the strength of the CFS channel sections, compared to an equivalent section having unstiffened holes, while still allowing full service integration. In the case of web crippling, previous research has found that use of edge-stiffened holes almost results in the same strength of an equivalent channel-section having a plain web. Such circular edge-stiffened web holes can now be extended to elongated edge-stiffened web holes. However, for such elongated holes, no experimental tests have been reported in the literature. In this paper, a numerical investigation was carried out, and non-linear finite element (FE) analyses were used to investigate the web crippling behaviour of CFS channel sections having edge-stiffened web holes under the interior-two-flange (ITF) loading condition. The cases of both flange fastened and flange unfastened were considered. The FE models were validated against test results of sections having circular edge-stiffened web holes; good agreement in terms of the load–displacement curves and deformed shapes was shown. Using the validated FE models, a parametric study was carried out on CFS channel sections having elongated un-stiffened and edge-stiffened web holes, comprising 1,227 finite element analyses (FEA) results. Compared to sections having a plain web, for the case of an elongated opening, without any edge-stiffener, having an aspect ratio of two and three, the average reduction in web crippling strength was 39% and 49%, respectively. However, for an edge-stiffened hole, the reduction in the web crippling strength was reduced to only 2% and 16%, respectively. Finally, the design equations in the form of the web crippling reduction factor (R p) and the equations based on the direct strength method (DSM) for CFS sections with elongated web holes were proposed. [ABSTRACT FROM AUTHOR]

• The structural behaviour of cold-formed steel T -stub connections with HRC and screws was studied experimentally and numerically. • The results of a total of 15 new experimental tests were reported. • Finite element analysis was conducted and validated against the test results. • The prediction accuracy of current design standards was evaluated. Cold-formed steel (CFS) T -Stub connections are widely used in single-story buildings, and their use is increasing in multi-story and long-span buildings. Recently, an innovative CFS T -Stub connection was developed using self-drilling screws and the Howick Rivet Connector (HRC), and such a newly-developed connection demonstrated excellent structural performance in the building industry. In this paper, a comprehensive experimental and numerical investigation was conducted to investigate the failure mechanism and structural behaviour of CFS T -Stub connections with a combination of HRC and screws under tension force, considering the effects of screw numbers. Firstly, a total of 15 new experimental tests were conducted on the CFS T -Stub connections with various numbers of screws. From the experiments, it was observed that the HRC was subjected to shear failures, while screws failed primarily due to tilting and bearing failures in all investigated specimens. Then, a non-linear elasto-plastic finite element (FE) model was developed and validated against the experimental results in terms of connection strength and failure modes. Finally, the design strengths obtained from the American Iron and Steel Institute (AISI 2016) & Australia/New Zealand standards (AS/NZS 2018) and Ahmadi et al. (2016) were compared with the test and FEA results, showing that the ultimate design strength of CFS T -Stub connections was overestimated by 16% and 14%, respectively. However, for T -Stub connections with HRC alone and with HRC and one screw, these design guidelines were unconservative by 5%. [ABSTRACT FROM AUTHOR]