Search

The opening up of the railway to competition in Europe has been accompanied by many technical challenges never before seen in the railway field. One of these challenges concerns precise energy metering. As European railways have been a monopoly until now, the current systems can only measure the energy consumption of a single operator. In accordance with European law, the installation of an energy meter has been mandatory in new or refurbished rolling stocks since 2014. Nevertheless, these energy meters are still not fully reliable, with misreadings and missing readings being common occurrences. To address the problem of energy metering data reliability, this paper presents a method for validating the reading measurement based on a physical model and validates it in two different case studies. For the issue of energy metering data availability, different estimators are developed, and their performance are shown with the aim of calculating the missing consumptions for both case studies. Finally, the paper suggests how these methods may be implemented in other types of trains. [ABSTRACT FROM AUTHOR]

The solutions recommended by international roadmaps and technical reports on smart metering refer to interval metering with time resolutions higher than 15 min to 1 h as traditionally used. Based on the characteristics of the users’ power patterns in distribution networks, this article shows that in practical cases the resolutions of the traditional metering are not sufficient to assess peak power and network losses effectively. Effective interval metering solutions should have resolutions of one minute or less. Moreover, this article shows the advantages of assessing the average power peak (amplitude and duration) and estimating the network losses through innovative solutions beyond interval metering, based on event-driven energy metering. The use of EDM significantly enhances the quality of pattern representation and reduces the amount of data required with respect to high-resolution interval metering. Based on the Pareto analysis of conflicting objectives, a novel procedure to set up the EDM thresholds is presented. The applications shown use real data and refer to a single user, some users connected to a distribution network feeder, and many users connected to a large distribution system. The EDM benefits are quantified using specific indicators that consider energy losses and peak power. [ABSTRACT FROM AUTHOR]

In 2015, the energy measurement of some static electricity meters was found to be sensitive to specific conducted electromagnetic disturbances with very fast current changes caused by highly nonlinear loads, leading to meter errors up to several hundred percent. This article describes new results on the electromagnetic compatibility (EMC) of 16 different meters from all over Europe when exposed to real-world disturbance signals. Those test signals were obtained from household appliances and onsite measurements at metered supply points all over Europe. The results show that also the interference signals recorded onsite can cause measurement errors as large as several hundred percent, even for meters that pass the present EMC standards. This unambiguously demonstrates that the present immunity testing standards do not cover the most disturbing conducted interference occurring in present daily-life situations due to the increased use of nonlinear electronics. Furthermore, to enable the adoption of potential new test waveforms in future standards for electricity meter testing, artificial test waveforms were constructed based on real-world waveforms using a piece-wise linear model. These artificial test waveforms were demonstrated to cause meter errors similar to those caused by the original real-life waveforms they are representing, showing that they are suitable candidates for use in improved standardization of electricity meter testing. [ABSTRACT FROM AUTHOR]