Search

Air pollution caused by coal burning not only increases the cost of environmental pollution but also harms human health. It is urgent for China to change the practice of coal-fired central heating. Therefore, the effectiveness and sustainability of the Coal to Gas and Electricity policy have become the focus of all sectors of society. In this paper, eight cities in the Beijing–Tianjin–Hebei region were taken as the experimental groups and the other eleven cities as the control groups. Based on the PSM-DID model and the time-varying DID model, a quasi-natural experimental analysis was conducted to evaluate the effect of the policy of coal to gas and electricity to improve air quality in the Beijing–Tianjin–Hebei region from 2015 to 2020 and to test the sustainability of the policy. Three research conclusions are shown below: First, during the implementation of the policy, especially in 2019, the AQI index decreased significantly. Although there was a rebound thereafter, it was still lower than before. This shows that the Coal to Gas and Electricity policy has indeed improved the air quality in Beijing, Tianjin, and Hebei during its implementation. Second, the policy had a great impact on SO2 and PM10 but was relatively weak on PM2.5 and CO. Therefore, there is an urgent need to formulate scientific and accurate policies to control different air pollutants. Third, the time-varying DID model was used to identify the dynamic sustainability effect of the Coal to Gas and Electricity policy. The results showed that the policy had a strong impact in the initial stage, but its effect was greatly reduced at the end of the implementation or near the end, when it was far less obvious than in the initial stage of the policy. Therefore, in formulating relevant measures to reduce air pollution, it is necessary to fully consider the sustainability of the policy. [ABSTRACT FROM AUTHOR]

Based on the mean sea level pressure field and 10-meter wind field across eastern China, weather patterns were classified using principal component analysis in the T-model (T-PCA), and four weather conditions were identified. Weather conditions and meteorological factors affecting the winter PM2.5 concentration in the Beijing–Tianjin–Hebei (BTH) region and the Yangtze River Delta (YRD) were also analyzed. The results showed that there were significant differences in the PM2.5 distribution between BTH and the YRD under different weather conditions. The intensity and path of cold air played important roles in regulating the PM2.5 concentration distribution in eastern China. For the BTH region, under type 2 and type 4 conditions, the weather was stable, and heavy pollution frequently occurred; however, under type 1 and type 3 conditions, cold air was active, and the air quality improved. For the YRD, both type 1 and type 4 conditions lead to high PM2.5 concentrations in this region. Type 1 cold air flows southward along the northwestern path and is beneficial for transporting pollutants from BTH to the YRD, causing a high probability of PM2.5 pollution. Conversely, the southward movement of type 3 cold air along the eastern path was beneficial for pollutant diffusion in the YRD. [ABSTRACT FROM AUTHOR]

Exploring urban spatial structures through spatial coupling analysis methods is an important method to provide theoretical support for the construction of sustainable urban structures. In order to make up for the neglect of POI species differences in previous studies, information entropy was introduced to calculate POI confusion, and a comprehensive POI index was constructed by combining kernel density and the entropy weight method; impervious surface coverage was extracted based on land cover data. The spatial distribution of the Beijing–Tianjin–Hebei urban agglomeration and some typical cities was analyzed by coupling two types of data using the dual-factor mapping method. The research indicates the following: (1). The spatial distribution of the two sets of data in the Beijing–Tianjin–Hebei region is highly consistent, indicating a state of high spatial coupling; Beijing has the highest proportion of coupling in the same region at the city level (73.39%). (2). The areas with different coupling of the two types of data are mainly distributed in the urban fringe areas transitioning from the city center to the suburbs, as well as in large-scale areas with single functionality such as airports, scenic spots, and ports. This study shows that analysis combining the POI comprehensive index and impervious surface coverage can effectively characterize urban spatial structure characteristics, providing a new perspective for the study of the spatial structure of the Beijing–Tianjin–Hebei urban agglomeration. It is of great significance for a deeper understanding of the laws of urban agglomeration spatial structures and guiding the coordinated development of the Beijing–Tianjin–Hebei urban agglomeration. [ABSTRACT FROM AUTHOR]

The heating and cooling energy consumption levels of urban buildings account for a large and rapidly growing proportion of the total end-use energy consumption of society. The urban heat island (UHI) effect is an important factor influencing the spatiotemporal variations in the heating and cooling energy consumption levels of buildings. However, there is a lack of research on the impact of the UHI on the heating and cooling energy consumption of buildings in cities of different sizes in the Beijing–Tianjin–Hebei urban agglomeration, which is the most urbanized region in northern China. We selected rural reference stations using the remote sensing method, and applied an hourly data set from automatic weather stations, to examine the impact of the UHI on the typical residential building heating and cooling loads in three cities of varied sizes in the Beijing–Tianjin–Hebei urban agglomeration through building energy simulation. The main conclusions were as follows. As the UHI intensity (UHII) increased, the heating load difference between urban and rural areas decreased, while the cooling load difference between urban and rural areas increased in the cities. The average daily heating loads in the urban areas of Beijing, Tianjin, and Shijiazhuang were 8.14, 10.71, and 2.79% lower than those in their rural areas, respectively, while the average daily cooling loads in the urban areas were 6.88, 6.70, and 0.27% higher than those in their rural areas, respectively. Moreover, the absolute hourly load differences between urban and rural areas were significantly larger during the heating periods than during the cooling periods, with the former characterized by being strong at night and weak during the day. During the peak energy load period, the contribution of the UHI to the peak load of residential buildings varied between the cities. During the stable high-load period, from 18:00 to 07:00 the next day in the heating periods (from 18:00 to 05:00 the next day in the cooling periods), the hourly loads in the urban areas of Beijing, Tianjin, and Shijiazhuang were 3.15 (2.48), 3.88 (1.51), and 1.07% (1.09%) lower (higher) than those in their rural areas, respectively. Our analysis highlights the necessity to differentiate the energy supplies for the heating and cooling of urban buildings in different sized cities in the region. [ABSTRACT FROM AUTHOR]

With the intensification of human activities, the natural water cycle has a significant nature-society dual feature, and identifying the mutual feedback mechanism between natural and social water cycles is an important basis for a more accurate simulation of the dualistic water cycle. In this study, two indexes of cumulative runoff change rate and social water cycle feedback rate are put forward, representing the degree of change in socio-hydrological unit runoff under the mutual feedback of the natural social water cycle in all upstream regions, and the degree influence of the water intake, consumption, and discharge process of the social water cycle on the natural water cycle in the socio-hydrological unit, respectively. Taking the Beijing–Tianjin–Hebei region, which is marked by strong human activities, as the study area, the 2035 natural-social dualistic water cycles were simulated by a water allocation and simulation (WAS) model. Different water supply types and use structures cause the social water cycle to increase or decrease local runoff in different areas. The social water cycle feedback rate is greater than 1 in Beijing and Tianjin, and less than 0.25 in the mountainous areas and the Hebei plain, indicating that the social water cycle of each unit in the Beijing–Tianjin–Hebei region increases or decreases local runoff due to different water supply types and use structures. The cumulative runoff change rate in this region was 0.66, indicating that the overall runoff was attenuated due to the social water cycle, and runoff attenuation was greater in the south than the north. [ABSTRACT FROM AUTHOR]

The urbanization process leads to the enhancement of the urban heat island (UHI) effect, and the high temperature brought by it exacerbates the risk of heat exposure and seriously endangers human health. Analyzing the spatiotemporal characteristics and levels of heat exposure risk is important for formulating heat risk prevention and control measures. Therefore, this study analyzes the spatiotemporal characteristics of heat exposure risk based on the UHI footprint (FP) and explores the relationship between it and urbanization factors in the Beijing–Tianjin–Hebei (BTH) region from 2000 to 2020, and obtains the following conclusions: (1) The BTH region suffers from severe UHI problems, with FP ranging from 6.05 km (Chengde) to 32.51 km (Beijing), and the majority of cities show significant trends of FP increase. (2) With the increase in FP, massive populations are exposed within the heat risk areas, with the average annual population at risk across cities ranging from 269,826 (Chengde) to 166,020,390 (Beijing), with a predominance of people exposed to high risk (more than 65% of the total) and generally showing increasing trends. (3) The population at risk of heat exposure is significantly correlated with urbanization factors, indicating that urbanization is an important reason for the increase in the risk population and the enhancement of the risk level. These results suggest that with the continuous urbanization process, the heat exposure risk problem faced by cities in the BTH region will persist and gradually worsen, which must be paid attention to and effective mitigation measures must be taken. [ABSTRACT FROM AUTHOR]