Search

Grinding aids to increase grinding efficiency in cement production are materials that can produce large amounts of high-quality cement in a short time by reducing surface energy by preventing particle agglomeration and improving fluidity. In the paper, a grinding aid using glycerol-waste antifreeze(GAP) is prepared and its effect on the grinding properties of clinker is investigated in contrast to that without the grinding aid. The results are as follows: The angle of repose of the cement powder added with GAP decreases as the grinding time increases (decreases by 3.8° when the grinding time is 60 minutes), indicating that it increases the flowability of the powder. On the contrary, the residual amount of 45µm sieve is also significantly reduced (4.6% decrease) and the specific surface area increases (30.5m2/kg), which results in an increase in the grinding efficiency. In the size range of 3 to 32µm, it increases the particle content, makes the particle size distribution uniform, the 7d and 28d activity index of the powder is improved by 5% and 6%, respectively, and increases the compressive strength of the cement. In addition, it is confirmed that the performance of the TEA grinding aid and the grinding aid are similar, and are very effective in terms of economy.

This paper summarized the research work carried out by a team from Department of Steel Structures and Structural Mechanics, together with Department of Materials Science and Engineering, from University Politehnica Timisoara, which tried to determine the possibility to use welding for obtaining built-up cold-formed steel beams made of corrugated galvanized steel sheets (grade S350GD+Z). There were analyzed two joining processes: MIG brazing and Resistance Spot Welding with the aim to replace the self-drilling screws used until now. The results are very promising and these solutions of joining have beside economic advantages also technical and quality ones.

The paper aims to report preliminary researches towards to development of new hybrid welding system by coupling a microwave beam with a TIG torch. The main research was focused on the designing of hybrid system as well as to establish the heating/welding mechanism by coupling two different thermal sources. Therefore, a specific welding chamber was designed taking into consideration the limitations provided by microwave waveguide technical specs, geometrical shape and dimensions of the TIG torch as well as the temperature monitoring during welding process and video surveillance for data recording. A microwave generator with adjustable power from 0 to 1250 W was coupled with a TIG torch and welding power source in order to establish the main parameters for hybrid system. The preliminary researches reported that the MW-TIG hybrid welding could be applied to eutectic joining of materials using low power (up to 600 W) injected from microwave generator as well as low welding current (up to 20 A). The flow of shielding gas have been established initially to 2 l/m. The research related to stabilization of MW-WIG plasma arc have been studied by increasing the flow of shielding gas up to 10 l/m. The results have shown that the microwave generator and TIG torch can be coupled to obtain hybrid-welding process without any matching tuning devices but with risks for damaging the microwave generator. Further researches will be done in order to design auxiliary devices to optimize the hybrid-welding process and to avoid any unwanted plasma arc discharge from welded base materials to microwave generator. In terms of temperature monitoring, an infrared pyrometer has been used. The IR pyrometer was targeted to the base materials in order to be able to measure their temperature without any influences from plasma arc. The results obtained have shown a stable plasma at average microwave power around 400 W even without any TIG current.

The paper presents the results of researches carried out by a joint team from Department of Steel Structures and Structural Mechanics, together with Department of Materials Science and Engineering, from University Politehnica Timisoara, focused on the possibility of creating built-up cold-formed steel beams made of corrugated galvanized steel sheets by resistance welding, which will replace the similar beams built by self-drilling screws. Resistance spot welding technologies were developed and tested, together with mechanical testing of the welded joints, which were performed in our laboratories. The results obtained and presented confirm the good quality of the welded joints and, as a result, the good capability of this technology to be used in production, to replace the old type of beams.